Owners manual

NEED ASSISTANCE?
•
87 7. 2 8 7. 8 6 3 4
•
RA
•
PAGE 2
Step 1
Starting on the driver side, locate the three
mounting locations underneath the vehicle.
Step 2
Starting at the front driver-side mounting
location, locate the four mounting holes.
There are threaded holes on select models.
If your model does not have threaded holes,
insert an M8 bolt plate.
Secure the top of the mounting bracket to
the vehicle using two M8 hex bolts, two M8
flat washers and two M8 lock washers.
Secure the lower mounting holes using
two 1/4" hex bolts, four 1/4" flat washers
and two 1/4" nylock nuts.
Snug the hardware, but do not fully tighten.
Step 3
Repeat step 2 for the middle and rear brackets.
Repeat this entire process on the
passenger side of the vehicle.
Note: To complete the installation,
refer to the manual included with
your side bars / running boards.