User's Manual

8.2 Reset Your Phone
Occasionally, you may need to reset your Pocket PC Phone. A normal (or soft)
reset of your device clears all active program memory and shuts down all active
programs. This can be useful when the device is running slower than normal or
a program is not performing properly. A soft reset is also necessary after the
installation of some programs. If a soft reset is performed when programs are
running, unsaved work will be lost.
You can also perform a hard reset (also known as a Cold Boot). A hard reset
should be performed only if a normal reset does not solve a system problem.
After a hard reset, the device is restored to its default settings (the way it was
when you first purchased it and turned it on). Any programs you installed, data
you entered and settings you customised on the device will be lost. Only
Windows Mobile
software and other pre-installed programs will remain.
To perform a soft reset
Locate the small hole on the left of the device known as the soft reset button
and, using the tip of your stylus, gently push the button inwards. This type of
reset will NOT affect your data. Otherwise simply remove the battery, wait a few
seconds and insert the battery again.
To perform a hard reset
Hard reset by accessing the Master Clear Application:
1. Tap Start > Settings > System tab > Factory Setting
2. Proceed to enter the confirmation code: 1234. Confirm by tapping Yes. The
system will reboot to complete the operation.
Alternatively, a hard reset may be performed using the following process:
1. Simultaneously hold the Power button and push the soft reset button inwards.
2. Release the buttons and the device will hard reset.