Installation Guide

Bathroom Accessories – Installation Manual

EASY INSTALLATION

According to the different bathroom accessories to install, firstly check the corresponding distance needed between the mounting plate(s) for

marking proper location(s) for the mounting plate(s) on wall.

1) Place the mounting plate(s), Fig. 1, vertically at the corresponding 2) Take away the mounting plate. Drill holes at the marked

location(s) on wall. Then, mark the screw holes locations on wall screw locations, Fig.2. On ceramic tiles, try to locate screw

through the upper & lower holes at the mounting plate. hole(s) on grout line. If mounting on tile surface, use

masking tape to do marking & to prevent sliding during

drilling.

3) Push the plastic anchors provided into the holes until flush with wall. 4) At last, place the Bracket clipping over mounting plate.

Then, screw mounting plates to wall with the screws provided, Fig. 3. Position the Bracket with set screw on its bottom side.

Note : Molly or toggle bolts (not included) may be required for Unscrew the set screw a little bit for proper fitting.

hollow wall. Clip the Bracket with its upper end to mounting plate first

Then, push the Bracket completely to flush with the wall.

Tighten the set screw to lock with mounting plate on wall

For product with two Brackets such as towel bars & some of the tissue paper holders, suggest to mount one Bracket first, then put the

towel bar or tissue paper holder in place. Check to ensure the assembly is level, and finish the mounting of the other Bracket.

Important

: To check that the product is securely mounted after assembly, pull the product slightly. If not mounted properly, unscrew the set screw

and re-tighten once again.

WT International Inc.

www.aristabath.com ARISTA

is a registered trademark of WT International Inc.