Installation Guide

Quick-Mount Design Bathroom Accessories ~ Installation Manual

EASY INSTALLATION – By just Clicking in a Second !

According to the different bathroom accessories to install, firstly check the corresponding distance needed between the mounting plate(s) for

marking proper locations for the mounting plate(s) on wall.

1) Place the Quick-Mount design mounting plate(s), Fig. 1, 2) Take away the mounting plate. Drill holes at the marked

vertically at the corresponding location(s) on wall with the screw locations, Fig.2. On ceramic tiles, try to locate screw

spring-pin on the bottom side. Then, mark the screw holes hole(s) on grout line. If mounting on tile surface, use

locations on wall through the upper & lower holes at mounting plate. masking tape to do marking & to prevent sliding during

drilling.

3) Push plastic anchors provided into the holes until flush with wall. 4) At last, clip the Bracket over the mounting plate by :

Then, screw mounting plate to the wall with the screws provided, ~ Position Bracket with its pin hole on bottom side. Match

with spring-pin on bottom side, Fig. 3. its pin hole with the spring-pin of mounting plate, Fig.4.

Note : Molly or toggle bolts (not included) may be required for ~ Then, push Bracket upward against the spring-pin until

hollow wall. the upper side of Bracket clips with the top of mounting

plate, Fig.5. Mounting is finished when clipping is done.

For product with two Brackets such as towel bars & some of the tissue paper holders, suggest to mount one Bracket first, then put the

towel bar or tissue paper holder in place. Check to ensure the assembly is level and finish the mounting of the other Bracket.

Important

: To check that the product is securely mounted after assembly, pull the product slightly.

If not mounted properly, repeat the clipping step.(4)

: For easy removal; the bracket can be simply detached by pushing the spring-pin upward,(with any small tool), through the pin

hole of the bracket and unclipping.

WT International Inc.

www.aristabath.com ARISTA

is a registered trademark of WT International Inc.