User's Manual
Wall Mounting the C-230
1. Drill four mounting holes in the wall.
2. Insert four anchors.
3. Ax mounting bracket on the wall
4. Attach device to the mounting bracket. Pull the
release key outward. Attach the AP stubs to the
bracket holder ensuring a rm t.
6. Fasten release key screw with a tamper resistant
T10 torx screwdriver to lock AP to the bracket.
5. Once attached, push in the release key to lock the
hooks and make sure all hooks are locked in place.
Note: If needed, the wall mounting accessory SKU (MNT-AP-FLAT-14CM) can be ordered and purchased
separately.
Getting the C-230 Online
Step 1: Power up
Plug one end of an Ethernet cable into the PoE+ (802.3at) switch or injector and the other end into the
Ethernet/PoE+ port on the C-230. Ensure the PoE+ source you are using is turned ON, or use a compatible
power adaptor (Arista SKU: PWR-AP-W4) to power the C-230.
Warning: If you are not using PoE+, ensure that you use only an AC power adaptor supported by the
C-230 access point (AP). This product is intended to be supplied by a Listed Direct Plug-In Power Unit
marked “Class 2”, Listed Power Adapter or DC power source marked “L.P.S.” (or “Limited Power Source”) and
rated from 12 V DC, 2.5A minimum.