Getting Started Instructions

5. Ensure that all the mounting posts on the
rear-side of the device are snapped in to the
respective notches on the bracket.
4. Rotate the device such that the center
mounting post ts in to the center notch on the
bracket.
Getting the C-250 Online
Step 1: Power up
Plug one end of an Ethernet cable into the PoE+ (802.3bt) switch or injector and the other end into the
Ethernet/PoE+ port on the C-250. Ensure the PoE+ source you are using is turned ON.
Note: You can also use PoE+ (802.3at).
OR
As an alternative to PoE+, you can insert a compatible power adaptor plug into an AC power outlet and
the other end into the power input port on the C-250.
Warning: If you are not using PoE+, ensure that you use only an AC power adaptor supported by the
C-250 access point (AP).
Wall Mounting the C-250
1. Drill four mounting holes in the wall.
2. Insert four anchors.
3. Aix mounting bracket on the wall 4. Attach device to the mounting