User's Manual

Wall Mounting the C-250/C-260
1. Drill four mounting holes in the wall.
2. Insert four anchors.
3. Ax mounting bracket on the wall
4. Attach device to the mounting bracket. Pull the
release key outward. Attach the AP stubs to the
bracket holder ensuring a rm t.
6. Fasten release key screw with a tamper resistant
T10 torx screwdriver to lock AP to the bracket.
5. Once attached, push in the release key to lock the
hooks and make sure all hooks are locked in place.
Note: If needed, the wall mounting accessory SKU (OEM-MNT-C110/C250-FLAT) can be ordered and
purchased separately.
Getting the C-250/C-260 Online
Step 1: Power up
Plug one end of an Ethernet cable into the PoE+ (802.3bt or 802.3at) switch or injector and the other end
into the Ethernet/PoE+ port on the C-250/C-260. Ensure the PoE+ source you are using is turned ON, or
use a compatible power adaptor (Arista SKU: OEM-PWR-W4) to power the C-250/C-260.
Warning: If you are not using PoE+, ensure that you use only an AC power adaptor supported by the
C-250/C-260 access point (AP). This product is intended to be supplied by a Listed Direct Plug-In Power
Unit marked “Class 2”, Listed Power Adapter or DC power source marked “L.P.S.” (or “Limited Power Source”)
and rated from 12 V DC, 3.3 A minimum.