Installation Guide

Deluxe Adj. CURVED Stainless Steel Shower Rod
Installation Manual
Congratulation you have purchased the ARISTA high quality 1”
Deluxe Stainless Steel CURVED Shower Rod ! Its patent pending
snap-fit mounting bracket facilitates an easy installation method for
you.
Below step-by-step instructions will guide you through in the simple
installation.
Adjustable 60” – 72” Deluxe Stainless Steel Shower Rod
In the package, there are two (2) pieces of Snap-Fit Mounting Brackets,
two (2) parts of the Curved Stainless Steel Shower Rod, four (4) pieces
of mounting screws and four (4) pieces of anchors included.
Mounting of Snap-Fit Brackets
1) Hold the Snap-Fit Mounting Bracket on to the desired position on each side of the
wall at outside rim of the tub.
Be sure the Snap-Fit Mounting Bracket in correct position with the screw holes at
12 & 6 o’clock positions.
Mark the drilling locations on the wall through the screw holes at the Snap-Fit
Mounting Bracket.
Note : Check the Snap-Fit Mounting Bracket on each side of the wall at same
height from the floor, in order to ensure the shower rod in level after
assembly.
2) Drill holes as marked on each side of the wall of the tub.
Two (2) holes for each Snap-Fit Bracket on each side of wall.
3) Push anchors into each hole on the wall until it flushes with the wall.
4) Mount each Snap-Fit Bracket on each side of the wall by screwing the mounting
screws provided through the holes at Snap-Fit Bracket into the anchors inserted
on wall.