Installation Guide

Be sure the Snap-Fit Brackets are properly installed with the screws securely
tightened.
Installation of Shower Rod to the Snap-Fit Brackets
1) Put the two (2) parts of rod together to form a complete Curved Shower Rod :
By sliding the end of the smaller diameter rod (with white plastic cap) into the
larger diameter rod.
This Curved Shower Rod could fit 60” – 72” (maximum) showers by sliding in or
out of these two parts of rod. No cutting is required.
Note : The end of each rod with snap-pin is for connecting with the Snap-Fit
Bracket. So, these ends with snap-pin should be on outside when sliding
together to form the complete Curved Shower Rod.
2) Press down the snap-pin on one end of the Curved Shower Rod and then, snap into
the Mounting Bracket on one side of the wall.
Repeat this step to install the other end of the Curved Shower Rod to the Mounting
Bracket on the other side of the wall.
You may use screwdriver or any hardware to help you pressing down the snap-pin
if needed.
Now, the installation is completed. It’s ready for use after you put on
your shower curtain.
For Care:
Clean regularly with warm water & soft cloth. Do Not use abrasive materials,
cleaners or detergents as they may be harmful to the finish.
Required Tools (Not included):
1) Philips head screwdriver,
2) Level,
3) Cordless Drill
4) Electronic Stud Finder if available
Reminder
1) According to any particular shape of your tub, you can adjust the installation
position of the Curved Shower Rod slightly more inward or outward from the tub as
you desire.
:
2) Unless there is a stud, each screw should be secured on to the wall by using the
anchor.
3) Do not mount on acrylic or fiberglass type of wall
Any questions can be sent to
[e-mail]
ARISTA
TM
is a trademark of WT International Inc.
Snap-Fit Mounting Bracket for Curved Shower Rod – Patent Pending