Installation Guide

Adjustable CURVED Shower Rod
Installation Manual
Congratulations, you have purchased the ARISTA® quality
Adjustable CURVED Shower Rod! Its patented snap-fit mounting
bracket facilitates an easy installation method to all.
Below is step-by-step instructions that will guide you through in the
simple installation.
Adjustable 60” – 72” Curved Shower Rod
In the package, there are two (2) pieces of Snap-Fit Mounting Brackets,
two (2) parts of the Curved Stainless Steel Shower Rod, four (4) pieces
of mounting screws and four (4) pieces of anchors included.
Mounting of Snap-Fit Brackets
1) Hold the Snap-Fit Mounting Bracket on to the desired position on each side of the
wall at outside rim of the tub.
Be sure the Snap-Fit Mounting Bracket in correct position with the screw holes at
3 & 9 o’clock positions.
Mark the drilling locations on the wall through the screw holes at the Snap-Fit
Mounting Bracket.
Note : Check the Snap-Fit Mounting Bracket on each side of the wall at same
height from the floor, in order to ensure the shower rod is level after
assembly.
2) Drill holes as marked on each side of the wall of the tub.
Two (2) holes for each Snap-Fit Bracket on each side of wall.
3) Push an anchors into each hole on the wall until it flushes with the wall.