Instruction booklet WASHER DRYER GB Contents English Installation, 2-3 GB Unpacking Remove the transit fixings Levelling Water connections Drainage and electrical connections Technical details Washer dryer description, 4-5 Control panel LEDs Starting and programmes, 6-9 A1600WD A1400SWD A1400WD A1200WD Briefly: how to start a programme Programmes table Setting the temperature Setting the spin speeds Functions Drying section Detergents and laundry, 10 Detergent dispenser Preparing your laundry Spe
Installation GB ! Keep this instruction manual in a safe place for future reference. Should the appliance be sold, transferred or moved, make sure the instruction manual accompanies the washer dryer to inform the new owner as to its operation and features. ! Read these instructions carefully: they contain vital information on installation, use and safety. Unpacking 1. Unpack the machine. 2. Check whether the washer dryer has been damaged during transport.
Installation Drainage connections B A A. Connect the drain hose, without kinking it, to a draining duct or a wall drain fixed at a height between 65 and 100cm from the floor. Use the curved bracket, if reqired. The first wash cycle Once the appliance has been installed and before you use it for the first time, run a wash cycle without detergent and no laundry, setting the 90˚C programme without a pre-wash cycle. Technical Details Models B.
Washer Dryer Description GB Control panel - Models A1600 and A1400 FUNCTION Buttons PROGRESS INDICATOR LEDs Programme key TEMPERATURE Knob Detergent dispenser DRYING Knob ON/OFF Button ON-OFF/DOOR LOCK LED START/RESET PROGRAMME Knob Button Control panel - Model A1200 FUNCTION Buttons PROGRESS INDICATOR LEDs Programme key TEMPERATURE Knob Detergent dispenser DRYING Knob ON/OFF Button ON-OFF/DOOR LOCK LED START/RESET PROGRAMME Knob Button Detergent dispenser: To add detergent and fabric softener (
Washer Dryer Description LEDs PROGRESS INDICATOR LEDs: These light up to indicate the progress of the selected programme. When the programme is started the light corresponding to the first cycle is lit and as the programme progresses, successive lights will come on until the programme finishes. Additional feature - Models A1600WD, A1400SWD and A1400WD only: Your machine has a delay timer function and there are additional markings alongside the LEDs.
Starting and Programmes GB Briefly: starting a programme 1. Switch the machine on by pressing the ON/OFF button , for at least 2 seconds. All the LEDs will light up for a few seconds and the ON-OFF / DOOR LOCK LED will begin to flash. 2. Load your laundry into the machine and shut the door. 3. Set the PROGRAMME knob to the programme required. 4. Set the wash temperature (see Personalisation). 5. Set the spin speed (see Personalisation). 6.
Personalisation Setting the temperature Functions Turn the TEMPERATURE knob to set the wash temperature (see Programme table). The temperature can be lowered, or even set to cold wash . To enable a function: 1. press the button corresponding to the desired function, according to the table below. 2. the function is enabled when the corresponding LED is illuminated.
Drying Section GB Drying programmes ! If your machine is not permanently plumbed in, turn on the cold water supply and hook the drain hose over the sink to enable the condensing action to work. Independent drying programme: 1. Remove the wet laundry and in drum dosing ball (if used) until the correct ‘Drying Weight Load’ (see table below) is left in the drum. Close the door until it clicks shut. 2. Select a drying programme (see Programmes): - 5 High Heat for cottons or - 9 Low Heat for synthetics 3.
Drying Section A typical wash and dry programme: 1. Sort your laundry into groups with the same wash and dry care labels. 2. Load the machine, making sure that items are not trapped in the door. Close the door by pushing it until it clicks. 3. Add detergent and fabric conditioner (if required), to the dispenser drawer. Refer to the detergent manufacturer’s dosage instructions. 4. Switch the machine on by pressing the ON/OFF button. The ON-OFF/DOOR LOCKED LED will illuminate. 5.
Detergents and Laundry GB How much does your laundry weigh? Detergent dispenser ! Do not put any items into the drawer, other than detergents designed to be released from the drawer, as they may cause damage or blockage. 1. Pre-wash detergent compartment. Maximum 200ml powder or 100ml liquid 1 2. Main wash detergent compartment. Maximum 400ml powder or 200ml liquid 3. Fabric conditioner compartment.
Precautions and advice ! The machine was designed and built in compliance with the applicable international safety regulations. The following information is provided for your safety and should consequently be read carefully. Saving on detergent, water, energy and time ● ● General safety ● ● ● ● ● ● ● ● ● ● ● ● ● ● This machine should only be used by adults and in accordance with the instructions provided in this manual. Do not overload the machine.
Care and maintenance GB Switching off the electricity ● ● Turn off the water tap after every wash. This will limit the wear of your appliances water system and also prevent leaks. Unplug your appliance when cleaning it and during all maintenance operations. Caring for your appliance door and drum ● Always leave the appliance door ajar to prevent unpleasant odours from forming.
Troubleshooting One day your machine seems not to be working. Before you call your Service Centre (see Service), go through the following troubleshooting suggestions: Problem: Possible causes / Solution: The machine won’t start? ● ● The wash cycle won’t start? ● ● ● ● ● The machine fails to fill with water? ● ● ● ● ● ● The machine continuously fills with water and drains? The machine does not drain or spin? The appliance is not fully plugged into the socket. There has been a power failure.
Troubleshooting GB Problem: The washer dryer vibrates too much during the spin cycle? The washer dryer leaks? Possible causes / Solution: ● ● ● ● ● ● There is too much foam? ● ● The machine does not dry? ● ● ● ● The ON-OFF/DOOR LOCKED LED flashes rapidly at the same time as at least one other LED? 14 ● The transit fixings were not removed correctly (see Installation). The washer dryer is not level (see Installation).
Service Before calling the Service Centre: ● ● Use the troubleshooting guide to see if you can solve the problem yourself (see Troubleshooting). If not, turn off the appliance and call the Service Centre closest to you. What to tell the Service Centre: name, address and post code. ● telephone number. ● the type of problem. ● the date of purchase. ● the appliance model (Mod.). ● the serial number (S/N). This information can be found on the data label inside the door of the machine.
195050451.01 06/2005 - SIMLEX .