Installation Instructions

9
EN
Table 2 - Technical Speci cations - *Nipple Adaptors Included in the Box
D. Technical Speci cations and Dimensions
Technical Data Units 2.5 4 8
Tank Capacity Gallons 2.7 4.0 8.0
Dimensions Inches
14
1/4
”W x
14
1/4
”H x 10
3/4
”D
14
1/4
”W x
14
1/4
”H x 12
3/4
”D
17
1/2
”W x
17
1/2
”H x 15
1/4
”D
Weight (Empty) lbs 15.5 17.6 29.5
Maximum Water Pressure psi 150
Recovery Rate (90
o
F Rise) gal/h 6.8 6.8
Temperature Range
o
Fahrenheit 65 - 161 65 - 161
Water Connections NPT 1/2” NPT
3/4” NPT Nipple
Adapters Included*
Relief Valve Installed Installed
Included, not
Installed
Nominal Voltage (1 Phase) VAC 110 / 120 (all Models)
Nominal Current Amps 12.0
Power at 120 VAC Watts 1440
Electrical Connection Plug In Hard Wired
A
AE
F
B
C
D
A
B
C 6
D
E 11
F
Figure 3 - Dimensional Drawing
Part 3 - Installation Instructions
A. Mounting the Water Heater
These water heaters are designed to be installed under the sink.
1. Wall Mounting
• Fasten the supplied mounting bracket to the wall.
• Hang the water heater on the bracket.
• Tug down on the water heater to ensure that both “ ngers” of the bracket are seated in the mounting slots.
2. Floor Mounting
The water heater can be installed on the  oor. Install the included adhesive rubber  oor mounting feet onto the
bottom of the water heater. See the rubber feet installation instructions included in the pack.
B. Plumbing
It is mandatory that all plumbing be done in accordance with federal, local, and state plumbing codes and
practices. Failure to properly install the water heater WILL VOID the warranty. It is also necessary to use both
thread tape and pipe dope on all mechanical plumbing connections.
Install unions on the hot and cold water connections to easily disconnect the water heater for servicing.
Use screws suitable for the wall material and the weight of the water heater. Failure to do so could result in
property damages and damage to the water heater. Such damages ARE NOT covered by product warranty.