USER MANUAL 520, 750 & 900 // UNDERMOUNT HOOD ARU52AX-L | ARU75AX-L | ARU90AX-L IMPORTANT // Please ensure that you read through this user manual prior to installation and use. This manual contains important information to ensure optimal performance and keep you safe. Please retain your proof of purchase, as this will be required in the event that you require warranty service. Remember to retain this manual for future reference.
HELLO CONGRATULATIONS ON THE SELECTION OF THIS SLIDEOUT RANGEHOOD. OUR APPLIANCES HAVE BEEN SPECIFICALLY DESIGNED FOR AUSTRALIAN AND NEW ZEALAND KITCHENS. Please read through this user manual carefully as it contains information that will ensure that your appliance is installed correctly, important operating & care instructions and also some advice of what you need to do if this appliance is not performing as intended.
CONTENTS HELLO 2 CONTENTS 3 WARNING & SAFETY INFORMATION 4 INSTALLATION & DUCTING 5 OPERATING INSTRUCTIONS 7 MAINTAINING YOUR RANGEHOOD 8 PROOF OF PURCHASE 9 NOTES CONTACT DETAILS 520, 750 & 900 // UNDERMOUNT HOOD 10-11 12 pg 3
WARNING & SAFETY INFORMATION This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. The minimum distance between the hob surface and the lowest part of the rangehood is 600mm. This distance shall be at least 650mm, if the rangehood is installed over a gas hob.
INSTALLATION & DUCTING 300/5 *ARU52AX-L *314mm for bevelled edge panel * 00/65 150 0 9 10/85 483/7 0 0 50/9 520/7 10 IMPORTANT Before handling the rangehood during installation, it is recommended that you remove the filter to prevent damage. Fig 1.2 illustrates the minimum height from the hob surface to the underside of the rangehood. Electric hob - 600mm Gas hob - 650mm NOTICE: IF THE INTRUCTIONS FOR THE GAS HOB SPECIFY A GREATER DISTANCE, THIS HAS TO BE OBSERVED.
INSTALLATION & DUCTING TOP DUCTING SIDE DUCTING RE-CIRCULATING (Carbon filter required) DUCTED OPTION NOTICE // ALL DUCTING MATERIAL MUST BE COMPLIANT WITH THE LOCAL LAWS IN FORCE. INSTALLATION 1. Remove the filter and light globes. (If installed) 2. Remove the stainless steel fascia (4 screws) – take care not to damage the fascia. 3. Determine the most efficient path for the ductwork, minimise bends and keep the length of the ductwork to a minimum. 4.
OPERATING INSTRUCTIONS FAN SPEED OFF/LOW/MEDIUM/HIGH switch - located on the left hand side of the control panel. This unit features 3 speed settings; single line indicate low speed, double lines indicate the medium speed & triple lines indicate high speed. To turn the unit off, set the speed switch to the 0 position (off). LIGHT On/Off switch - located on the right hand side of the control panel as indicated in the diagram above.
MAINTAINING YOUR RANGEHOOD GENERAL MAINTENANCE Ensure that the power to the unit is switched off prior to cleaning the unit. Surface should only be cleaned with warm soapy water and a soft non-abrasive cloth. In coastal environments and humid areas more frequent cleaning is required to maintain the finish. FILTERS These filters should be cleaned frequently, dependant on use (minimum monthly). Aluminium filers are dishwasher safe or can be cleaned with hot soapy water.
PROOF OF PURCHASE ATTACH YOUR PROOF OF PURCHASE FOR FUTURE REFERENCE 520, 750 & 900 // UNDERMOUNT HOOD pg 9
NOTES pg 10 520, 750 & 900 // UNDERMOUNT HOOD
NOTES 520, 750 & 900 // UNDERMOUNT HOOD pg 11
CONTACT DETAILS AUSTRALIA ARISIT PTY LIMITED 40-44 Mark Anthony Drive Dandenong South, VIC 3175 Australia Ph 1300 815 589 FX (03) 9768 0838 consumer.care@arisit.com NEW ZEALAND ARISIT PTY LIMITED PO Box 68-140 Newton, Auckland 1145 New Zealand Ph (09) 306 1020 FX (09) 302 0077 sales@aristonappliances.co.nz ARISTON IS COMMITTED TO ONGOING RESEARCH AND DEVELOPMENT. EVERY EFFORT HAS BEEN MADE TO ENSURE ALL INFORMATION IN THIS USER MANUAL IS CORRECT AT TIME OF GOING TO PRINT.
