INSTRUCTION FOR USE Slim Hood ASL 6F LT X
INSTALLATION GUIDE Read all installations before installing this appliance ! IMPORTANT SAFETY NOTICE WARNING 2
The installation in this manual is intended for qualified installers, service technicians or persons with similar qualified background. Do not attempt to install this appliance yourself. Injury could result from installing the unit due to lack of appropriate electrical and technical background. All electrical wiring must be properly installed, insulated and grounded.
By ensuring this product is disposed correctly, you will help prevent negative consequences for the environment and human health which could otherwise be caused by inappropriate waste handling. The symbol on the product indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal.
Fig.1 Fig.2 Fig.
Connection to power Make sure that the voltage of power network match with the one that is written on the type board of the absorber plate.The connection to power must be handled by an authorized technician. The power cord must include a bipolar switch with contact separation distance over or equal to 3mm. The device must be able to disconnect from the power supply. Operation In order for the hood to function effectively, you have to switch it on from the moment you switch on the hob.
Filter cleaning or replacement Attention:During filter cleaning or replacement procedure, the hood must be plug off. In order to replace or clean the filter you have to: 1. Remove the aluminum filter by pressing the filter buttons. Now you are able to change or clean the filter. The aluminum filter should be washed by dishwasher or by hands every 30 days. Please make sure the filter is dry before you assemble them back. Do not neglect to clean the aluminum filter regularly (every 2 months).
Lamp replacement During lamp replacement procedure, the hood must be plug off. The replacement of the lamps is made if you open the aluminum filter by moving the filter buttons as the arrows shows on Fig.6. Then remove the plastic covers of the lamps carefully according to the picture below. Replace the lamp with a 40 watt incandecent lamp. Caution: -The surface and the cover of the lamp may be hot. PAY ATTENTION when replacing. Fig.
Attention It will be dangerous in the following cases: - Do not disassemble the grease filter when the hood is working. - Do not touch the lamps or surfaces surrounding after the hoods have been working for a long time. - Do not leave bare flames under the range hood, it may damage the filter or cause a fire. - Deep fat fryer must be continuously monitored during use: overheated oil can burst into flame. - Disconnect all the electricity before any maintenance work.
TECHNICAL DATA (ASL 6F LT X) Electricity Voltage 220-240 Frequency Installation Distance V 50 Hz mm Gas hob 650 750 Cable length 150 mm Plug type UK Plug with safety mark Electric hob mm Power Total 240 Fan motors 200 40 W
TROUBLE SHOOTING The cooker hood may not work or work improperly. Before calling the After-sales service, switch off the appliance, unplug the power supply and refer to this guide to determine the problem.
Warranty 11