IMPORTANT SAFETY INSTRUCTIONS Warning When using electrical appliances, basic safety precautions to reduce the risk of fire, electric shock or injury to persons should be followed, including: 1.READ ALL INSTRUCTIONS BEFORE USING THIS WATER HEATER. 2.This water heater must be grounded. Connect only to properly grounded outlet. Use only the 3 prong plug that comes with the water heater. Do not use an adapter to bypass the ground connection. 3.
C E 0,8" DIMENSIONS FOR P10 S / P15 S MOD A B C D E P10 S 14" 10 1/4" 14" 3 1/2" 6 1/8" P15 S 14" 12 1/4" 14" 3" 6 1/8" General Remarks Caution The manufacturer cannot be responsible for the damages caused by improper installation or by failure to follow instructions in this pamphlet. Comply with the installation instructions before completing electric connection. Caution The thermostat has been pre-set at the factory to about 60°C/140°F.
Pipe Connections Connect the cold water inlet pipe to the inlet nipple (marked with a blue ring - #1, Fig. 4). IMPORTANT: You must use dielectric fittings if inlet piping/fittings are copper or brass. Failure to provide dielectric insulation may result in premature tank or nipple failure and will void warranty. Dielectric nipples are recommended over unions and are available from a supply house or CEC.
Instructions for use Starting and testing Before connecting the power, fillthe tank and system with water and check for leaks. To be certain that all the air is out of the water system, open the hot water faucets on your fixtures until constant water flows from them, otherwise damage to the element may occur. To start the heating cycle: A) first make sure tank is full. Otherwise the heating element may be damaged. B) move red on/off switch (letter F, Fig 3-4) to the ON position (to the left).
Descaling the heating Element Scale deposits can affect the heating capability of the element. Heavy scale can even cause the element to burn out. The element can be descaled either chemically or manually: A) Soak the element in white vinegar or other descaling solution, (do not soak the rubber gasket).
Resetting High Limit Switch Occasionally, the high temperature limit shut off device may trigger and shut the system down. This occurs when water temperature exceeds 190°F and shuts off power to the heating element. The shut off device may also trigger from a power outage or electrical storm. To reset: 1. IMPORTANT: Disconnect heater from electrical power. 2. Remove front cover plate and temperature selector dial. 3. Firmly press blue reset button, (B, Fig. 3-5). 4.
ARISTON • LIMITED 2 YEAR WARRANTY COVERAGE ARISTON, THROUGH ITS U.S. DISTRIBUTOR CONTROLLED ENERGY CORP., (hereinafter CEC) guarantees this water heater to the Owner (hereinafter "Owner") of the water heater at the original installation location against defects in material and workmanship for the periods specified below. 5.
COMMON SENSE HEAT & HOT WATER TECHNOLOGY Controlled Energy Corp. 340 Mad River Park Waitsfield, VT 05673 800-642-3111 802-496-4436 Fax: 802-496-6924 www.controlledenergy.
ARISTON P10 & P15 INTERIOR COMPONENTS DIAGRAM 1. 2. ANODE ROD P10 / P15 574305 HEATING ELEMENT 810847 4. FLANGE GASKET 570016 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17.