imp.
imp. HOTPOINT sidebyside 3 17-04-2007 8:16 Pagina 2 Before using the appliance GB ! Your new appliance is designed exclusively for domestic use. ! After unpacking the appliance, make sure it is not damaged and that the door closes properly. Any damage must be reported to the dealer within 24 hours of delivery of the appliance. ! Wait at least two hours before switching the appliance on, to ensure that the refrigerant circuit is fully efficient.
imp. HOTPOINT sidebyside 3 17-04-2007 8:16 Pagina 3 Safeguarding the environment Packing Declaration of conformity The packing material is 100% recyclable and bears the recycling symbol. For disposal, comply with local regulations. Keep the packing materials (plastic bags, polystyrene parts, etc.) out of reach of children, as they are a potential source of danger. • This appliance has been designed for preserving food and is manufactured in compliance with Regulation (CE) No. 1935/2004.
imp. HOTPOINT sidebyside 3 17-04-2007 8:16 Pagina 4 Precautions and general recommendations GB Installation Safety • The appliance must be handled and installed by two or more persons. • Be careful not to damage the floors (e.g. parquet) when moving the appliance. • During installation, make sure the appliance does not damage the power cable. • Make sure the appliance is not near a heat source.
imp. HOTPOINT sidebyside 3 17-04-2007 8:16 Pagina 5 If the appliance is not going to be used In case of power failures of up to 24 hours GB Keep the doors of the appliance closed. In this way the stored food will stay cold as long as possible. For further information see chapter “Using the appliance”, section “Black-out alarm”. If the appliance is not going to be used • Disconnect the appliance from the power supply. • Remove all food if you are going away for more than three weeks.
imp. HOTPOINT sidebyside 3 17-04-2007 8:16 Pagina 6 Maintenance and cleaning GB • Before any cleaning or maintenance operation, always disconnect the appliance from the power supply. • Periodically clean the appliance with a cloth and a solution of lukewarm water and neutral detergent specific for refrigerator interiors. • Never use detergents or abrasives. Never clean the refrigerator parts with flammable liquids. The fumes can cause fires or explosions.
imp. HOTPOINT sidebyside 3 17-04-2007 8:16 Pagina 7 Storing, freezing and thawing food Introduction Defrosting Wrap food so that no water, moisture or condensate can enter; this will prevent odours or aromas going from one part to another in the refrigerator, ensuring better preservation of frozen foods. Use plastic containers with hermetic lids, aluminium trays, aluminium foil, plastic film and waterproof plastic wraps. NOTE: Never place hot food in the freezer.
imp. HOTPOINT sidebyside 3 17-04-2007 8:16 Pagina 8 Description of the appliance GB REFRIGERATOR COMPARTMENT A. Inside light B. Inside light - NOT FITTED C. Adjustable shelf D. Shelf - drawer lid E. Crisper F. Crisper adjustment G. Meat / vegetable drawer H. Meat / vegetable drawer adjustment I. Dairy products compartment J. Door trays K. 2-litre door tray with bottle holder L. 0.75 litre door tray 8 Downloaded from Fridge-Manual.com Manuals FREEZER COMPARTMENT M.
imp. HOTPOINT sidebyside 3 17-04-2007 8:16 Pagina 9 Guide to the inside parts Removing and repositioning the refrigerator compartment and freezer shelves. The shelves can be positioned as required. The glass shelves are strong enough to hold bottles, milk cartons and heavy food, however, take care not to bang products on the shelves. To remove the shelves: pull the shelf out as far as it goes, then lift and remove it. Removing the crisper or meat drawer: 1. slide the drawer out as far as it goes; 2.
imp. HOTPOINT sidebyside 3 17-04-2007 8:16 Pagina 10 Using the appliance GB FIRST USE GUIDE TO SELECTING FUNCTIONS Connect the appliance to the power supply (refer to the Installation manual). When connecting the appliance to the power supply, the freezer compartment display will show two dashes until the optimum internal temperature has been reached, whereas the refrigerator display indicates a temperature of 5°C (factory-set).
imp. HOTPOINT sidebyside 3 17-04-2007 8:16 Pagina 11 Using the appliance Refrigerator temperature The factory-set ideal temperature is +5¡C. To change the temperature, press the uttons until reaching the required value that it will be displayed. Fast cooling (refrigerator compartment) This function is used to speed up the cooling process for fresh foods. It can be activated by pressing the : button: the light comes on.
imp. HOTPOINT sidebyside 3 17-04-2007 8:16 Pagina 12 Troubleshooting guide GB Before contacting After-sales Service... Operation problems are often due to minor causes that can be found and fixed without using any tools. Noises from the appliance are normal, since the fans and compressors for controlling its operation switch on and off automatically.
imp. HOTPOINT sidebyside 3 17-04-2007 8:16 Pagina 13 Troubleshooting guide If moisture has accumulated: • Make sure the air ducts inside the compartment are not blocked and thus GB preventing the circulation of air. • Make sure food is properly packaged. Dry any wet food containers before placing them in the appliance. • Make sure the doors are not opened too frequently. When the door is opened, the moisture contained in the room air enters the appliance.
imp. HOTPOINT sidebyside 3 17-04-2007 8:16 Pagina 14 Assistance GB Guarantee 12 Months Parts and Labour Guaramtee Your appliamce has the benefit of our manufacturer’s guarantee, which covers the cost of breakdown repairs for twelve month the date of purchase. This gives you the reassurance that if, within that time, your appliance is proven to be defective because of either workmanship or materials, we will, at our discretion, either repair or replace the appliance at no cost to you.
imp. HOTPOINT sidebyside 3 17-04-2007 8:16 Pagina 15 Assistance After Sales Service No one is better placed to care for your appliance during the course of its working life than us - the manufacturer. Essential Contact Information Hotpoint Service We are the largest service team in Europe offering you access to 400 skilled telephon advisors and 1100 fully qualified engineers on call to ensure you receive fast, reliable, local service. UK: 08709 066 066 Republic of Ireland: 0818 313 413 www.
imp. HOTPOINT sidebyside 3 17-04-2007 8:16 Pagina 16 Electrical connection for Great Britain and Ireland only 5019 615 02010 GB Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows: 1. Remove the fuse cover (A) and fuse (B). 2. Fit replacement 13A fuse into fuse cover. 3. Refit both into plug.