Operation Manual

14 ARISTON DISHWASHER - Instructions for installation and use
D
ISHWASHER
How to load your dishes
First of all.
Before placing the dishes in the
racks, remove the largest
scraps of food left over on your
plates, you will thus avoid
blocking the filter, which would
reduce the efficacy of the wash.
If the saucepans and frying
pans are very dirty, allow them
to soak before being washed.
To make it easier to load your
dishes, pull the racks out.
What goes into the
lower rack?
We recommend you place the
most difficult dishes to wash
into the lower rack: saucepans,
lids, soup dishes and plates (a
load example is shown in the
photo).
 Serving dishes and large
lids: place them on the sides
of the rack.
 Saucepans, salad bowls:
must always be placed
upside down
 Very deep dishes: place
them obliquely, thus
allowing water to run down
them and cleaning them
better
The cutlery basket is equipped
with two removable grids:
insert the cutlery one by one
into the slots, with the handles
at the bottom (Fig. A and B).
Knives and utensils with sharp
blades or tips should be positioned
with the sharp parts at the bottom.
Position them so that they don't
touch.
It is best if you place longer utensils
horizontally at the front of the
upper rack.
What goes into the
upper rack?
Place delicate and lightweight di-
shes in the upper rack: glasses, tea
cups and coffee cups, saucers - but
plates too - shallow salad bowls,
slightly dirty frying pans and
shallow pans (the photo illustrates
a few examples).
The appliance can also be equipped
with one or two tip-up compart-
ments onto which you can place
mugs and cups, as well as long sharp
knives and serving cutlery.
Position lightweight dishes in such
a way as to avoid their being mo-
ved by the spray of water.
After loading the dishes, remem-
ber to check that the blades on the
sprayer arms can turn freely wi-
thout knocking against any dishes.
How to adjust the top
rack.
The upper rack can be set in
high or low position to enable
you to organise your dishes
effortlessly.
Before washing, a few small steps can help you get a better wash and keep your dishwasher for longer. Remove the largest scraps
of food left over on your plates, soak saucepans and frying pans with tough incrustations. After loading your dishes, make sure
the blades on the sprayer arm turn well.Do not place glasses and cups on top of one another, and make sure the dishes are not
touching.
lower rack
upper rack
Load examples
Open the rail stop flaps and pull the
rack out completely. Now place it in high
or low position, then slide it along the
guide rails until the front wheels also go
in. Now close the rail stop flaps. Follow
the sequence of actions illustrated in
figure "F".
1
2
3
4
Fig.F
Fig. A
B