Operation Manual

ARISTON DISHWASHER - Instructions for installation and use 15
D
ISHWASHER
You have loaded your dishes and you now have to set the
wash cycle. It takes just one minute to learn how
Starting the dishwasher
Ready, steady, go!
You can cancel the
wash cycle in
progress, if it has
only just started.
Make sure the wash
cycle has ended
before removing the
dishes!
If opening the door
soon after the end of
the programme,or
during it, stand away
from the Dishwasher,
to avoid possible
injury from hot
steam.
First of all.
After performing all the
operations described in the
previous paragraphs, turn the
water tap on completely and
press ON-OFF button "A": you
will hear a short beep and
indicator light "B" lights up.
Now the appliance is on and
ready to be programmed.
Selecting the wash
cycle.
To select the wash cycle, turn
knob "D" clockwise until the
reference notch on the knob
corresponds with the number
or symbol for the cycle you
wish to set (have a look at the
wash cycle table on page 17).
For a few seconds, the
indicator light "G" concerning
the pre-wash cycle phase
begins to flash, then it stays
permanently on without
flashing for another 10 seconds
approximately. During this
time, you can modify your
choice of wash cycle. A short
beep will indicate the start of
the wash cycle and indicator
light "G" corresponding to the
cycle starting phase will light
up.
The dishwasher keeps
you informed.
Your dishwasher is fitted with
indicator lights (G) which light
up to indicate the cycle phase
under way.
Here are the symbols corre-
sponding to each cycle phase:
pre-wash, wash, rinses, drying.
At all times, your dishwasher
tells you which cycle phase is
under way.
Modifying a wash cycle
in progress.
But if you have chosen the
wrong cycle, not to worry! You
can modify the wash cycle in
progress, if it has only just
started. Turn the knob anti-
clockwise until it reaches the
Reset position and, after a few
seconds, you will hear 4 beeps
and indicator light "G" will turn
off. This is to inform you that
all the settings have been can-
celled. You are now free to re-
set the correct wash cycle.
You've left out a dish?
Well, it happens to everyone.
Interrupt the wash cycle by
pressing the ON-OFF button,
insert the dish you had forgot-
ten and press the ON-OFF but-
ton again. The cycle will start
up from where you interrupted
it.
Finished?
The end of the wash cycle is
indicated by two short beeps
and the flashing of the drying
phase indicator light.
Turn the knob anti-clockwise to
Reset in order to reset all the
settings.
Turn the appliance off to cut off
the electricity supply.
Turn off the water tap.
Wait a few minutes before un-
loading the dishes: they are very
hot! If you wait a little while,
they dry better thanks to the
steam.
Empty the lower rack first.
There's been a power
failure? Have you
opened the dishwasher
door?
The wash cycle stops and then
restarts when the electricity
comes back on or when you
shut the door. Everything is
under control!