Operation Manual

14
GB
The machine will start an automatic descaling cycle
with pauses programmed by the manufacturer and
automatically managed by the machine.
The display will show:
MACHINE IS DESCALING
6. At the end of the cycle, dispensing of the descaling
solution will stop and the display will show:
RINSE MACHINE
FILL WATERTANK
7. Rinse the water tank
thoroughly and fill it with
fresh drinking water.
Replace the tank and
close the front panel.
The display will show:
RISCIACQUARE
PREMERE TASTO ACQUA
8. Place a suitably sized
container below the
steam spout and press
the key.
Rinsing of the machine
circuits begins and the
display will show:
MACHINE IS RINSING
9. When the rinse cycle is complete, the display will
show:
RINSING FINISHED
PRESS WATER KEY
12. Fill the water tank, press the key, reprime the
circuits and leave the machine to heat up.
! If you are using a product other than the
recommended one it is important to follow the
manufacturer’s instructions shown on the pack of the
descaling product.
Interrupting the descaling cycle
If the descaling cycle is interrupted by the machine
switching off, it is resumed when the machine is
switched on again.
The descaling cycle may be interrupted by pressing the
key; the display shows:
MACHINE IS DESCALING
INTERRUPTED
press the key and the descaling cycle resumes. If
the key and the key are pressed, the display
shows:
DECALCIF. INTERROTTA
SVUOTARE SERB. ACQUA
Warning! After the operation, empty the water tank of
the descaling solution and wash it with fresh drinking
water. The machine’s circuit must be washed with a
rinse cycle.
Proceed as for a normal rinse cycle as described at
point 7 of the previous chapter.