Installation and Maintenance

\ 7

7. MEMORY button

It is used to save the current settings or restore the previous settings.

8. UP button

Press this button to raise the set temperature or to increase the time value during the

timer programming.

NOTE:

All the function described above are carried out by the internal unit. If the latter does not

have a certain feature, by pressing the respective button on the remote control system

no operation is activated.

13. LED button

It deactivates and activates the LED function.

14. LOCK button

Press together Clean button and Turbo button at the same time more than 5 sec

All buttons will not response except pressing these two buttons for two seconds

again to disable locking.

9. DOWN button

Press this button to lower the set temperature or to decrease the time value during

the timer programming.

10. ECO (in models equipped with this function)

Used to enable and disable the ECO function.

11. FAN SPEED / SILENCE button

Use this button to select the fan speed in the four options available in sequence:

AUTO > LOW > MED > HIGH

Press and hold for 2 seconds to enable the SILENCE function

12. TIMER button

It is used to set the automatic start up/shut down delay via the timer. Each time the

UP/ DOWN button is pressed, the delay setting increases/decreases by 30 min.

When the set delay reaches the value of 10:00, as indicated on the display, each

time the UP/DOWN button is pressed, the automatic shut down delay setting

increases/ decreases by 60 minutes. To cancel the programming via the timer,

just set the delay to 0:00.