Installation guide

IR FEEDTHRU
IR
o
1. Connect a ~" Stereo MINIJACK to control the RCC600-SA via your integrated control
system.
2. Both the IR Feedthru Jack and the Front Panel IR receiver are designed to allow the User
functions to be programmed into an external remote. The Hexadecimal codes for the
amplifier are located on the web at: http://www.artisonusa.com
POWER MODES
POWER MODES
0:::
w
eel
~el
Z :::J ii: +12V
e < ~ TRIGGER
~ INPUT
rn
1. Select either:
ON - Always On.
AUTO - On with Signal Sense, without signal it will stay on for ~15 minutes.
TRIGGER - On with a 12 Volt trigger.
2. +12V
Trigger Input - Use the Green Phoenix Connector to connect a 12 volt trigger wire
from your other equipment, the polarity on the connector can be either way.
SETUP MODES
~- SETUP MODES - ........
PHASE LOW PASS
80Hz.
O'~l80' 4llHZ~60HZ
OJ OJ
---J L..- ---J L.-
ao Baffle CLOSED 12dB 24dB
EQ BOX SLOPE
1. EQ - Select the appropriate setting based on these guidelines:
10