Installation guide

to be raised to achieve the previous volume levels.
If your normal listening position
is located in a null, then the only way to truly even out the null
is by either moving the subwoofer location to change the room modes that are stimulated OR
install a distributed bass system. Distributed bass uses multiple subwoofers in different
locations
in order to stimulate more of the room modes. It has been shown that this type of
system mitigates Eigen-modes and provides a more uniform response to a wider listening
area. Each RCC300-SA has the capability for running two RCC300-SM, or two RCC300-FS.
_-- EQ MODES ---.
en a
en W
~ ~
> :::l
m c(
to
C~R'~ JITO EO
MIC
°O@
1. AUTO EQ MIC - This is the input jack for the ARMC Microphone.
2. Switch Settings - Select either:
a. BYPASS - ARMC not active.
b. AUTO EQ. - ARMC active. Will remember the last measured room mode se.quence
and settings.
3. BLUE LED STATUS INDICATOR
a. Continuous Short Flash - Switch in AUTO EO setting, ARMC not yet saved. Since
the amplifier leaves the factory with this function having been tested the LED should
not flash continuously even when the switch
is set to the AUTO EO position. NOTE: It
is important that you do a room mode set up using the supplied microphone at
your normal listening position if you plan to use the amplifier in this setting
b. One Long, Two Short Flashes - Amplifier Error, Shorted Audio Outputs. Remove
the speaker wires from the amplifier and use an ohm meter to check for shorts
in the line.
c. One Long, Three Short Flashes - Over Temperature Indicator. Be sure that the
amplifier has adequate ventilation. If the situation continues to exist contact
Artison.
4. Calibrate Button - Place the supplied microphone in the desired listening position and
plug it into the AUTO EO MIC input jack. Press the button for a few seconds to initiate
ARMC sequence.
12