Installation guide
RCC 300 SUBWOOFER MODULE (RCC300-SM)
The RCC 300 Subwoofer Module can be installed into either an:
• Artison Pre-Build Box (Volume
::=
0.6
ft3)
SOLD SEPERATELY
OR
• Infinite Baffle (i.e. 2x4 stud wall, 16" On Center spacing
at
least
4 feet tall, Volume 1.4
fe
or
greater)
IMPORTANT: In an
installation
of
two
RCC300-SM's
that
are
being
powered
by
one
RCC300-SA,
both
Subwoofer
Modules
need
to
be
in
either
Pre-Build
Boxes
or
be in
Infinite
Baffles.
You
cannot
connect
two
RCC 300
Subwoofer
Modules
that
are
in
different
environments
to
the
same
RCC 300
Subwoofer
Amplifier.
The front
of
the RCC300-SM and the grille can be painted. The RCC300-SM comes from the
factory with a paint-shield attached. When painting the RCC300-SM, ONLY paint the grille and
outer edge
of
the module using the included paint-shield. DO NOT
get
paint
on
the
rear
of
the
subwoofer
module.
Paint
can
damage
the
components
which
would
VOID
your
Warranty.
The minimum mounting depth for the RCC300-SM is 3%" (95.5 mm), i.e. a 2x4 stud
is
3~"
deep
add
~",
~"
or %" thick drywall and the RCC300-SM will fit. The maximum drywall thickness the
RCC300-SM can be mounted
in
is
1.3125" (33.3 mm).
INSTALLATION WITH AN ARTISON PRE-BUILD BOX (Preferred
Installation)
1. Please refer to the Installation Guide included
in
the Artison Pre-Build Box Carton for
installation instructions for your Artison Pre-Build Box.
2. Using the speaker wire already run inside the Pre-Build Box, manage the speaker wire around
the RCC300-SM.
3.
Connect the bare speaker wire ends to the spring-loaded binding posts.
4.
Install the RCC300-SM into the pre-cut opening
of
the Pre-Build Box.
5.
Carefully tighten the four dog leg clamps on the RCC300-SM using a #2 Philips Head
Screwdriver.
6.
The grille for the RCC300-SM is held
in
place by magnets. Simply position the grille on the
front
of
the module i'lto the recessed area.
NOTE:
While
installing
the
subwoofer
module
make
sure
that
any
excess
wire
is
run
properly
so
that
it
does
not
interfere
with
the
driver's
operation.
The
design
of
the
RCC300-IWPBB
is
such
that
there
is
NO
clearance
between
the
back
of
the
subwoofer
module
and
the
back
of
the
box.
Be
careful
that
no
wires
are in
this
area
when
installing
the
module.
4