Installation guide
INSTALLATION
INTO
AN
INFINITE
BAFFLE
1. Use the provided Cut-out Template to mark the desired wall location. Be
sure
that
no
piping,
wall
studs,
or
electrical
wires
interfere
with
the
placement
of
the
RCC300-SM.
2. Once the hole is cut and the speaker wire
is
run, manage the speaker wire around the
RCC300-SM.
3.
Connect the bare speaker wire ends to the spring-loaded binding posts.
4. Install the RCC300-SM into the cut-out made
in
the wall.
5.
Carefully tighten the four dog leg clamps on the RCC300-SM using a #2 Philips Head
Screwdriver.
6.
The grille for the RCC300-SM is held
in
place by magnets. Simply position the grille
on
the
front
of
the module into the recessed area.
NOTE:
While
installing
the
subwoofer
module
ensure
any
excess
wire
is
run
properly
so
it
does
not
interfere
with
the
driver's
operation.
5