Installation guide
RCC 300
SUBWOOFER
AMPLIFIER
(RCC300-SA)
The RCC 300 Subwoofer Amplifier can be installed into either cabinetry,
on
an equipment shelf, or
it can be rack-mounted into a standard 19" Equipment Rack.
In
any
installation
be
sure
to
provide
adequate
ventilation
around
the
amplifier.
The RCC300-SA has two simple and conveniently placed mode settings. The Music or Movie
user controls are located on the front panel for selection based
on
the source material. The Mode
settings, Volume and Power Controls
of
the RCC300-SA can be accessed via IR codes. The
remote included with your unit can be downloaded into a learning remote or HEX Codes are
available
on
the Artison Web site. The Front Panel
of
the RCC300-SA has an IR Receiver and
there is a second hard wired feed thru jack that can be connected to an integrated control system
on the rear panel. Each control
is
described
in
detail below.
RACK-MOUNT
INSTALLATION
OF THE RCC300-SA
1. Remove the amplifier's four feet from the bottom
of
the chassis.
2. Attach the included rack-mount ears to the front sides
of
the RCC300-SA.
3.
Mount into the 19" equipment rack,
the
amplifier
will
occupy
1.5 RU. Using the supplied
~
RU
Blank Spacer either above or below the amplifier will occupy 2 RU.
4. If installing two RCC300-SA then the rack-mount ears can be flipped to accommodate
t~e
two
amplifiers
in
3 RU.
RCC300-SA REMOTE
CONTROL
The remote control has the following functions:
1.
ON/OFF - This will toggle between Standby Mode (Amber Halo) and
ON
(Blue Halo).
2.
MUSIC - This selects the MUSIC EO. When active it will have a Red Halo added to the Blue
Halo.
3.
MOVIE - This selects the MUSIC EO. When active it will have a Red Halo added to the Blue
Halo.
4.
GAIN - This will raise and lower the volume
of
the amplifier. A remote
or
the volume controls
on
the front panel can both be used to raise or lower the volume. NOTE: The
gain
control
is
configured
so
that
the
"last
used"
device
setting
will be
remembered
by
the
amplifier.
7