Installation guide

RCC300-SA FRONT PANEL CONTROLS
'"
/
RC(fLDJ
GAIN DIM
POWER MUSIC IoIOVlE
·0·
0
0
0 0
0
o • 10
RTISON
V
'"
GAIN - The position of this knob controls the overall gain (volume) of the subwoofer. Press
this button
in and it will spring out into a rotating knob, press it back in to hide it. The front panel
gain control will become the master gain control until the remote is used. NOTE:
The
amplifier by default will resume to the last setting by either gain control device.
DIM - This button controls the brightness of the Halo lighting on the front panel. There are
four brightness settings.
POWER - This button will toggle between Standby Mode (Amber Halo) and
ON (Blue Halo).
MUSIC - This preset EO mode should
be used for music playback. This EO setting provides
a full range
of musical bass to enhance the listening experience, when active it will add a Red
Halo to the Blue Halo.
MOVIE - This preset EO mode should be used for movie playback. This
EO setting adds
more volume and bass to help recreate the true movie theater experience, when active it will
add a Red Halo to the Blue Halo.
RCC300-SA REAR PANEL
L
r
J
~
r-POWER MODES-,...-- EQ MODES - ~ AUDIO OUTPU::y:= AUDIO =~ - r-- SETUP MODES AUDIO OUTPUTS -------., 0'fIIA I0 CJ 0
.. ~ ~ ~ ~= ~; ouro .. ill oo~oo a@).~"i; ~~$$ 1~:~~050g~~~:::~;~: ~AC;INS ~ P~OoWER ON ~
O
CJ D I I r:::.--i., L-J. • .. ,. _ .. - 0 O-.ue'-C ~'U'2--o (/ 1,91 III [g] ~
CJ ~o 'I ~ ~ OFF 1
AC POWER
I '
CI\IIT1DIt
~=:~
~~ODO
120VAC-60Hz Fuse:T5AL AC MAINS POWER
230VAC0e:T2'5~ ~ @ ~ ::F
1. The Power Switch is the hard ON/OFF power switch for the amplifier.
8