RWC Issue: F Description: ARISTON WALL CANOPY Model Numbers: RHC60IX, RHC90IX All dimensions in mm Model may vary slightly from images pictured 1
Overview view Pre-installation Thank you for purchasing a quality Ariston rangehood. Ariston has a high standard of quality control and every rangehood is tested and approved before it leaves the factory. Important: o Please read the entire instructions before installing the rangehood. o Always switch power off prior to installation. o Stainless steel is very easily damaged during installation if abraded or knocked by tools. Protect the rangehood with the cardboard box or plastic bag during installation.
Pre-Installation - continued Ducting Options The method of ducting should be carefully considered before installing the rangehood. The guide below recommends the ducting components to use for all common ducting configurations - through the top of the home (for the roof and soffit) and through the rear of the home. 150mm round ducting should be used in conjunction with this model rangehood. Alternatively this rangehood can be operated in recirculation mode (see Recirculation mode pg 6).
Pre-Installation - continued Installation position C C B A A Minimum height from the hob surface to the underside face of the rangehood 600mm electric hob 650mm gas hob Notes: If the instructions for the gas hob specify a greater distance, this has to be taken into account. Any installation above 750mm will compromise performance. B Vertical height from bottom of Rangehood to Fixing Plate mounting screws 323mm. C Distance between mounting screw holes on Fixing Plate 100mm.
Installation Mounting to a stud is recommended. However, if fitted to other wall linings (plasterboard, concrete etc) suitable fixings will be required. Before drilling any holes check that the wall and ceiling are clear of any electrical cables, pipes etc. Rear wall Wall stud Fixing screw Fixing plate 1. Pre drill pilot holes in the positions given (pg 4 - Installation position).
Installation - continued 5. Connect and secure the ducting (use duct tape if required). 6. Remove the protective plastic covering from all parts including the filters. Fit the canopy hood on the fixing bracket. Mark and drill the two holes required for the safety screws. Secure the canopy in place with the safety screws provided. The safety screws stop the canopy from accidently being knocked off the fixing plate. 7. Insert the upper chimney piece into the lower chimney piece.
Operating instructions Controls Power On/Off Speed 1 Speed 2 Speed 3 Lights On/Off Light The light can be operated independently from the fan and is controlled in accordance with the graphics printed above. Fan The fan is operated by turning the power switch on. It can be run at three different speeds (Speed 1 / Speed 2 / Speed 3) depending on the cooking requirements and is controlled in accordance with the graphics printed above.
Product approvals and ratings Product approval number VO71158 Product rating 280W (1.15A) Max at 240V 50Hz Electric approval AS/NZS 60335.2.
ECN: 07034
