Service manual

7 of 19
Indesit Company
Service Manual UK English
PROGRAMMES
1. Select HIGH HEAT by pressing the
HEAT button.
2. Position the PROGRAMS knob
on
A .
3. Press the START button.
Program
What it does... How to set it...
Note:
Dries completely: your clothes
are ready to be worn.
Regular Cottons,
Permanent Press.
! If you select LOW HEAT,
this program will not dry your
clothes. For Acrylic bers or
small loads select Timed
Drying.
Timed Drying
up to 170 minutes
Dries wet clothing that will be
ironed, acrylic bers or small
loads (less than 2 lb / 1 kg).
Consult suggested drying
times ( see Laundry).
1. Select required heat setting HIGH
HEAT or LOW HEAT by pressing
the HEAT button.
2. Position the PROGRAMS knob on
the desired time.
3. Press the START button.
Easy Iron Program
Easy Iron is a short 10 minute program (8 minutes of heat followed by a 2 minute Air Flu period) which us the
bers of clothing that have been left in the same position/location for an extended period of time. The cycle relaxes
the bers and makes them easier to iron and fold.
! Easy Iron is not a drying program and should not be used for wet articles of clothing.
For best results:
1. Do not load more than the maximum capacity.
These numbers refer to the dry weight:
daolmumixaMcirbaF
Regular Cotton and Regular Cotton mix 5.5 lb / 2.5 kg
gk2/bl4sserPtnenamreP
gk2/bl4mineD
2. Unload the dryer immediately after the end of the program, hang, fold or iron the articles and put them away.
Should this not be possible, repeat the program.
The Easy Iron eect varies from one fabric to the next. It works very well on traditional fabrics like Regular Cottons
or Regular Cotton mix, and less well on acrylic bers.
1. Select HIGH HEAT by pressing the
HEAT button.
2. Position the PROGRAMS knob on
.
3. Press the START button.
Fabric Care
Easy Iron
Fabric Care
Automatic
Drying
Brief program (approximately
10 minutes) that softens bers
of clothing that is ready for
ironing.
! This is not a drying
program ( see below).
Always allow the dryer to
complete this phase.
This is the nal phase of all programs.
Approximately 10 minutes before the
nish, the knob advances
automatically to the Air Flu phase.
After this the clothing is ready to be
taken out.
Heating elements turn
themselves o and clothing is
cooled down.
Fabric Care
Air Fluff Phase
A