Operation Manual

62
English
Troubleshooting (cont’d)
Recordings are not
occurring as scheduled.
New recordings cannot be
made.
A DVD+RW or DVD+R
recorded on this DVD
recorder will not play on a
DVD player.
The message 'Disc contains
unknown data' appears.
– The TV channel you want to record is not stored or you selected
the wrong programme number. Check TV channels stored.
– If you adjust the clock after you set a timer recording, reset the
timer recording.
– If the DVD recorder cannot read the disc, you cannot record.
– You cannot use the DVD recorder to duplicate copyrighted
materials (DVDs or videotapes) onto a DVD+RW/+R, “COPY
PROTECT” will be displayed.
– A finalised DVD+R has been inserted. Change disc.
– If a recording is too short, it is possible that a DVD player cannot
detect it. Please observe the following 'minimum recording
times'. Recording mode : {M2} – 10 minutes, {M2x} – 13 minutes,
{M3} – 15 minutes, {M4} – 20 minutes, {M6} – 30 minutes,
{M8} – 30 minutes.
– Some DVD players cannot playback DVD+RW recordings. You
can solve this problem by using a special function :
1) Press OPEN/CLOSE on the DVD recorder to open the disc
tray.
2) Insert the disc but do not close the tray.
3) Hold down the number button {2} on the remote control until
the tray closes. The disc is modified.
4) If this fails to produce the desired result, repeat the procedure
using the number button {3} on the remote control.
5) You can restore the disc to its original condition by pressing
and holding number button {1}.
Warning! There is a risk that you can no longer play the disc on
other DVD players after the following procedure. Therefore,
apply this function with particular care.
– This message may appear if you insert a disc that was not
finalised. DVD+R's that have not been finalised are very sensitive
to fingerprints, dust, or dirt. This may cause problems during
recording. To use the disc again, do the following :
1) Make sure that the surface of the disc is clean.
2) Press OPEN/CLOSE on the DVD recorder to open the disc
tray.
3) Insert the disc but do not close the tray.
4) Hold down button number {5} on the remote control until the
tray closes. The DVD recorder will start the repair process.
5) If the disc is recovered, the Picture Index screen will appear.
Please observe the following:
– Error during recording : The title may be missing.
– Error while changing the title/index picture : The original title/
index picture may be visible.
– Error while finalising : The disc appears not to have been
finalised.
Problem Solution
001-070_xRV645_Eng02 11/07/2005, 01:03 PM62