Installation Instructions
96
CS175-275-575-875 Installation Guide
The following guidelines should be followed when programming the RX8i4-16i4 modules.
•
When a transmitter is learned into memory, the module starts from that specific
locations.
•
Transmitters take priority over the hardwire on-board zones. Use the on-board
hardwire zones first and start learning transmitters in the next zone.
"
Before you start programming, use the 910# command to default the RX8i4-16i4 module.
Steps
1. Press 8 to enter programming mode.
2. Enter a Go to Program Code. The keypad prompts you to enter a module number.
3. Enter the module number and press
#
. The module number is the DIP switch
setting and can be from 32 to 39.
4. For new installations, press
910#
to set the default module settings.
5. Press 193#, change the flags 1-2-4 and press . This enables the Auto advance
feature after each zone is learned in.
6. Press
194#
, followed by
1
, to start learning in from zone 9.
7. Press 0# to enter the starting sensor learning location.
8. Press XX where XX is the zone number (1 to 168) and is the entry key.
9. Trip the desired transmitter (within 250 seconds) as described below. Listen for
the ding-dong for confirmation. If option 193, segment 1, option 2 is enabled, the
panel automatically switches to the next zone to learn in the next transmitter.
10. Repeat steps 5 to 7 to program the remaning transmitters.
11. Press the
Exit
key twice to exit programming mode.
"
Three beeps from the keypad indicates an entry error. This occurs if you enter a
transmitter number that is not within the module’s zone block or if you try learning a
sensor that is already learned into the the module..
Transmitter Action
Door/Window
Activate tamper switch by removing the cover.
Door/Window with
external contact
Activate tamper switch by removing the cover (Feature 3,
input option 1, must be on).
PIR
Activate tamper switch by removing back plate from PIR.
Smoke detector
Press and hold the test button.
Single Button Panic
Press and hold the button.
Keyfobs
Press and hold the arm and disarm buttons together.