Owner's Manual

RF Certification Owner’s Manual
903xxxxx
May 18, 2020
the fob is present, and the ignition switch is set to IGNITION.
NOTE
Movement like lifting the motorcycle off of its jiffy stand or a
NO FOB condition, will cause the system to electronically seek
the presence of the fob. If the fob is present, the system
disarms.
See OPERATION, Instruments.
When the system disarms, the siren (if equipped and in chirp
mode) chirps once.
.
Once disarmed, the rider can ride or move the motorcycle for
parking, storage or service without setting off the alarm.
Personal Identification Number (PIN): If the fob is misplaced
or if the fob fails to communicate, the system can be disarmed
with the Personal Identification Number (PIN). Refer to
SECURITY SYSTEM, Personal Identification Number (PIN).
ALARM
Warnings
Once armed if the motorcycle is moved or lifted off of its
jiffy stand and the fob is not present, the alarm will warn the
operator with two sequence of three alternate flashes of the
turn signals and a chirp of the siren (if equipped).
Within four seconds, if the motorcycle is back on its jiffy stand
and no further motion is detected, the system will remain
armed
without activating the alarm.
If the motorcycle motion continues, the system will issue a
second warning a few seconds after the first.
NOTE
During warnings and alarms, the starter motor and the ignition
circuits remain disabled.
Alarm Activation
If the security system is still detecting motion after a second
warning, the system will activate the alarm.
When activated, the security system will:
• Alternately flash the four turn signals.
• Sound the siren (if equipped).
Duration: If motorcycle motion is detected the system will
repeat the 30 second alarm and will continue to check for
motion. The alarm will repeat this 30 second alarm cycle for 5
minutes (10 cycles) or until no more motion is detected. The
alarm will then deactivate.
NOTE
The alarm will also activate the LED, vibration or audible
modes
of an optionally purchased Harley-Davidson Security Pager.
See a Harley-Davidson dealer for details.
Alarm Deactivation
Key fob: Bring the fob to the motorcycle. After the module
identifies that the fob is present, the system will terminate the
alarm.
PERSONAL IDENTIFICATION NUMBER (PIN)
If the fob is misplaced or fails, a personal identification number
(PIN) can disarm the security system. The dealership assigns
the initial PIN.
Disarming with a PIN
NOTE
If a mistake is made while entering the PIN, turn ignition OFF