Owner's Manual

RF Certification Owner’s Manual
903xxxxx
May 18, 2020
Number (PIN) has been entered in the system. Record
the PIN on the Personal Information page in the front of
this Owner's Manual and on the removable wallet card.
• If the fob is misplaced or fails, the rider can refer to the
wallet card and use the PIN to manually disarm the
system. See SECURITY SYSTEM, Arming and Disarming
and SECURITY SYSTEM, Troubleshooting.
• The rider can change the PIN at any time. See SECURITY
SYSTEM, Personal Identification Number (PIN).
Fob Battery
Replace the fob battery every year.
NOTES
• The reusable label found on the fob packaging lists the
serial number of the fob. For reference, affix the label to
a blank "NOTES" page in this Owner's Manual.
• See Figure 10. The serial number of the fob is also found
on the inside of the fob.
1. See Figure 10. To open the fob, turn a thin blade in the
slot (1).
2. Remove the battery (2) and discard in accordance with
local regulations.
3. Install a new battery (Panasonic 1632 or equivalent) with
the positive side down.
4. Align the two halves of the fob. Snap the halves together.
Riding with a Fob
• Always carry the fob when riding, loading, fueling, moving,
parking or servicing the motorcycle.
• Do not leave the fob attached to the handlebars or store
the fob in a luggage compartment. Unintentionally leaving
the fob with the motorcycle when it is parked prevents the
system from activating the alarm.
• Do not ride with the fob stored in a metal case or with the
fob closer than 76 mm (3.0 in) to a mobile phone, PDA,
display or other electronic device. Any electromagnetic
interference may prevent the fob from disarming the
system.
• For added security, always lock the fork and remove the
key when parked. If the fob is within range and the
motorcycle is unlocked, tampering with the motorcycle will
not activate the alarm.
Riding without a Fob
If the motorcycle is ridden without the fob in acceptable
proximity,
The Display screen will temporarily displays "NO FOB."
To restart a motorcycle without a fob, disarm the security
system with the PIN.
TRANSPORT MODE
It is possible to arm the security system without enabling the
motion detector for one ignition cycle. The motorcycle can be
moved in an armed state. The motorcycle cannot be turned on
or started while in transport mode until the fob is present.
To Enter Transport Mode
1. With security fob present, set the ignition switch to
IGNITION.
2. Set the ignition switch to OFF and within 3 seconds.
3. Press and hold left turn + FTP switch for > 1 second.
4. Following a single flash, the turn signals flash three times
to indicate that the system is armed in transport mode.
To Exit Transport Mode