Installation manual

Standard Features
• Ultra low power drain MCM
• Built-in Analog Devices accelerometer
• Remote sensor control
• Battery safeguard with “sleep mode”
• Violation display
• Selectable auto/ manual arming / disarming
• Flashes signal lights
• Integrated 120 dB multi-tone siren
• Remote panic feature
• Soft chirp arming
• Three-Stage Perimeter Sensor
• Selectable Perimeter Sensor arming
• Flash input for diagnostics and possible future upgrades
• Programmable override code to disarm alarm
• Built in back up battery
Optional Accessories
• Ignition disable and anti-hijack kit - Allows remote disabling of the
motorcycle’s electrical system should someone force you off your bike. Also
prevents the engine from being started when the system is armed.
• Factory Connector Kits –OEM style connectors that simply plug into the
motorcycle’s factory wiring harness. Connector kits are available for select
motorcycle models.
2
Components List
MCM (Main Control Module)
* Remote Transceiver
Generic Installation Kit (GEN-1) Accessory Harness (ACC-1)
Main Harness (HAR-1)
RFID Module
*This remote transceiver uses a CR2032 battery. To replace the battery pry the cases apart
using a flathead screwdriver at the small end of the remote. Then slide the screwdriver
towards the button until the case halves come apart. Now pull the circuit board out of
the rear case half and replace the battery. Last, snap the circuit board back into the rear
case and the two case halves back together and you’re done.
Planning the Installation
It is very important that before starting the installation of the security system, you carefully
read the installation instructions and spend time planning the installation. By planning
ahead you will be able to select the best approach in placing, securing and wiring the
system to your specific motorcycle. Although the installation is not difficult there are a
number of steps that must be taken for the system to operate properly. We suggest you
read the steps on the following page.
3