User`s guide

RCS (Range Confirmation Signal)

If the transceiver is within range of the MCM and the alarm is activated then the LCD will display

icon.

If the transceiver does not receive the RCS; the icon will not appear.

Checking Violation Display with Time Stamp

Press button

4 once

If no alarm triggers in memory, all

sensor icons will be displayed

If the system was triggered, the last triggered

sensor will be displayed

Trigger # Total # of

triggers

Time of trigger

Press button 4 repeatedly to

scroll though the trigger memory

Pres button 3 to exit and clear.

Or, press and hold button 3 for two

seconds to erase memory.

Button 1

Encoding a Transceiver

1. Unplug HAR-1 from the MCM-55 and plug it back in, the siren will chirp 2 times and the

lights will flash 2 times.

2. Within 6 seconds of plugging in the HAR-1 turn ignition switch “ON” and “OFF” 3 times.

3. If step 2 is done correctly and within the time allowed , the siren will chirp 2 times and the

lights will flash an additional 2 times to confirm that the system is in “Learn Mode”.

4. Press and hold button 1 until the system chirps 2 times and the lights flash 2 times to

indicate that the MCM has learned the code. The transceiver echoes 4 chirps and the LCD

displays [LErn donE] to confirm that the transceiver is encoded.

5. If you are encoding a second transceiver repeat step number 4 for the second transceiver

before continuing to step number six.

6. Turn ignition “ON” and “OFF” to exit “Learn Mode”.

Note: The transceivers are programmed from the factory. Encoding is only necessary should

the transceiver lose its code and will not arm or disarm the security system or if a second

or re

lacement remote is obtained.