User`s guide

a1
Problem Possible Cause Solution
Will not arm
Key pad is locked
Unlock key by holding button 4 for
four seconds
Power or ground not connected
Verify connection to power lead and
ground connection
Turn signals will not
flash
Grey wires from GEN-1 not
connected or connected to wrong
wires
Test wires and change connections
to correct wires
Perimeter Sensor not
working
Sensor not connected Check connections
System activated with wrong button
Activate with button 3 instead of
button 1
Ignition Disable does
not work
Orange wire from GEN-1 not
connected
Connect orange wire from GEN-1 to
12 volt (+) with ignition key on. In
most bikes that is the tail light wire
Ignition disable not connected to
correct wire on bike
Refer to options on the ignition
disable instruction page. Test
selected wire before reconnecting
RID-5 wires.
Troubleshooting guide
2
Transceiver Information
Alarm Triggers 14
Range Confirmation Signal 15
Checking Violation Display 15
Transceiver Battery Information 16
Low Battery Stages 16
Optional Accessories Instructions
Perimeter Sensor (SN 5) 18
Back up Battery 19
Ignition Disable / Anti hijack Unit 20-21
Appendix
Trouble Shooting guide a1
Limited Warranty a2
Important Information / Notes a3
FCC Information a3
Special Note a3