User`s guide

Extension 12”
A
ntenna 6”
5
Note: Connect the (HAR-1) harness to the MCM only after installation is completed.
Note: When the main harness (HAR-1) is plugged in, the siren should chirp. If the siren does not chirp; check
the alarm inline fuse, connection to battery
(
+
)
,and connection to
g
round
(
-
)
.
Note: If the battery is to be removed, disconnect HAR-1 connector first. Reconnect only after battery terminals
are reconnected.
Installation Warnings and Notes
Mounting the Components
Select a suitable location underneath the seat or in a side cover. Mount components using velcro
or cable ties. Make sure that the components are not exposed or accessible. While the MCM will
work in any position, placing it in a flat position will provide better performance.
Routing the Antenna Wire
For best performance the last 6” of the antenna should:
o Be as vertical as possible.
o Be away from metal as much as possible.
Making Connections
The necessary connector or wires are found under the seat or in the tail section of the bike.
Removal of the tail section plastics or side cover might be necessary.
21
Ignition / Engine Control Wire Options:
Option #1: Positive lead wire on fuel pump
Option #2: Positive lead wire on fuel injection system
Option #3: Positive wire that goes to the ignition fuse in fuse box. This should be either a 10 or
15 amp fuse labeled IGN. (Carbureted Bikes Only)
Option #4: Ground wire from ignition module
Option #5: Positive wire from ignition module to ignition coil
Operating the Anti-Hijack Feature
While the engine is running, press and hold the transceiver’s button 1 and button 2 at the same time
for 5 seconds. The siren will begin to chirp confirming that the Anti-Hijack feature has been
activated. 15 seconds later, the siren will go off continuously, and the engine will shut down. To
disarm, turn off the ignition switch and press button 2.
To CUT wire on motorcycle
To Accessory Harness on Main
Control Module (MCM)