User`s guide

Perimeter Sensor (SN-5)
Mounting the SN-5
The Perimeter sensor uses high frequency microwave technology to detect mass density movement
around the motorcycle. The signal can transmit through the seat, fiberglass, leather and plastic, but
not metal. It is recommended to place this sensor under the seat as close as possible to the center
of the motorcycle. With the provided Velcro, you can mount this sensor on top of the battery or any
flat surface, making sure that the top side of the sensor is facing upwards. Place the perimeter
sensor as faraway from the MCM as possible.
Adjusting the Sensor
Although the sensor is pre set from the factory it may be necessary to adjust the sensitivity to suit your
specific application. Remove the plastic cap and turn the adjustment screw.
To increase sensitivity, turn adjustment screw clockwise.
To decrease sensitivity, turn the adjustment screw counter clockwise.
Plastic Cap:
Remove to adjust
sensitivity
To Accessory Harness on Main
Control Module (MCM)
Note: Do not turn sensitivity above half way. Doing
so may cause false alarms.
18
8
Operating Instructions
The following instructions assume that the transceiver is within range of the motorcycle.
Arm
Disarm
Arming With Opt Perimeter Sensor
Arming Without siren (Paging only)
Arming Without Siren or Opt Perimeter Sensor
(Paging only)
Panic / Stop Trigger
Press button 1
Screen will show
Press button 2
Press button 3
Siren:
Chirp 3 Times
Turn Signals:
Flash 1 Time
Siren:
Chirp 1 Time
Turn Signals:
Flash 1 Time
Screen will show
Siren:
Chirp 4 Times
Turn Signals:
Flash 1 Time
Press button
1 and 3
Screen will show
Press button
2 and 3
Siren:
Chirp 5 Times
Turn Signals:
Flash 1 Time
Siren:
Chirp 6 Times
Turn Signals:
Flash 1 Time
Screen will show
Press button 3
(When armed)
Siren:
Sounds for a
few seconds
Note: When
p
ressin
g
button 1
,
2
,
or 3 the icon will flash to confirm the command has been sent.
Screen will show