Installation manual

Mounting the Components
Select a suitable location under the seat or in a side cover. Mount the MCM using Velcro
or cable ties. Make sure that it is not exposed or easily reached.
Note: Although the system will work in any position or mounting angle, try to avoid placing the
MCM with the bell of the siren facing toward either side of the bike; this may reduce sensitivity
Routing the Antenna Wire
The MCM includes an 18” antenna wire. The first 12” is a coaxial wire; the remaining 6” is
the actual antenna wire. When routing, try to avoid running the antenna along or near
metal. For best performance, try to have at least a portion of the antenna wire exposed.
Wire Connections
The MCM is equipped with two connectors. One is for the main harness (HAR-1) and the
other is for the optional accessories.
Accessory Harness
Plug in the accessory harness to the matching connector on the MCM. Each one of the
connectors on the accessory harness is unique and can only be connected into the
correct corresponding accessory. If no options are being used, plug in the supplied dust
cover.
Main Harness
If the optional factory connector kit is being used, please disregard this section of the
instructions and refer to the instructions that were supplied with the factory connector kit.
The main harness consists of two harnesses. One is labeled (HAR-1) and the second is
labeled (GEN-1). Plug in the white 4 pin connector from the (HAR-1) into the matching 4
pin connector from the (GEN-1). The (HAR-1) also has a waterproof connector that plugs
into the MCM. The wires should be connected as follows:
HAR-1
Black wire with fuse and ring terminal – To battery Positive (+).
GEN-1
Black wire – To ground (-).
Grey wire – To turn signal power wire (Left).
Grey wire – To turn signal power wire (Right).
Orange wire – To tail light wire or any other wire that is hot (+) when ignition is ON (NOTE:
this is an input to the alarm this connection is not designed to flash the tail light).
Note: When the main harness (HAR-1) is plugged in, the siren should chirp and turn signals should
flash twice. If the siren dose not chirp; check the fuse, and battery (+) and ground (-) connections.
If the turn signal lights do not flash, make sure that the Grey wires are connected to the turn signal
power (+) wires. Connecting these wires incorrectly may damage the system.
3
Color Codes:
Ground (-) Tail Light Left Turn Signal Right Turn Signal
Honda Green wire Brown wire Orange wire Blue wire
Kawasaki Black wire Red wire Green wire Grey wire
Suzuki Black/White Brown wire Green or Black Grey wire
Yamaha Black wire Blue wire Green wire Brown wire
Harley Davidson
Black wire Blue wire Brown wire Purple wire
Fuse
To Battery (+)
Accessory
HAR-1 Connector
GEN-1
Black – To Ground (-)
MCM Grey – To Turn Signal
Grey – To Turn Signal
Orange – To Tail Light
Note: Connect the (HAR-1) harness to the MCM only after installation is completed.
If the battery is to be removed, disconnect this connector first. Reconnect only after battery
terminals are reconnected.
Using the T-tap Connectors
1) Place female T-tap connector over wire to be tapped, close and squeeze until it snaps.
2) Now slip male T-tap connector over hinged end of the female connector.
Motorcycle Wire
1)
Female T-tap
2) Female T-tap
Male T-tap
Motorcycle
Wire
Wire from (GEN-1)
4