Installation Guide

front edge of the ZTE1222 Curb. Position the
guide just to the side of the panels, slip the
front lip in, then snap the guide down over the
inside of the curb. Slide the guide over carefully.
When the doors are in a closed position the
center guide should be centered in the overlap
of the glass.
(K) For added security you can at-
tach the guide after it is snapped in place by
drilling with a 1/8” drill bit through the snap in
leg into the curb(from the inside of the shower)
then running a #6X3/8 screw into the hole.
7) *please see attached before proceeding
Attach the ASD-1 (#10) Knob Pull
(L) by insert-
ing the threaded bolt with grommet through
the hole. This will be the inside panel with one
hole which will be on the showerhead side of
the opening. The knob should be on the inside.
Also make sure the plastic washers provided are
on each side of the glass. Use the small Allen
wrench provided to insert into the small hole on
the bolt head. Turn and tighten the bolt until
the knob is secure. Over tightening can cause
the glass to blow up.
8) Attach the towel bar (M) on the outside
panel with two holes using the same method as
the knob in step 7.
9) Run a bead of silicone on the gap between
the metal and the shower surface inside and
out. Fill all joints and gaps where metal meets
metal and fill with a fine bead.
(N)