Installation Guide

ManualsBrandsArizona Shower Door ManualsBathroomEuro 76.375-in H x 56-in to 60-in W Semi-Frameless Sliding Matte Black Shower Door (Clear Glass)

1

2

3

4

5

6

until the top rollers can be guided up into the

inside roller track of the header. Lift up glass

then slowly lower the rollers into the inside

roller track and let the panel hang in its vertical

position. The outside panel will be installed the

same way. Make sure the rollers are facing to-

ward you. A helper would be valuable at this

point to hold the inside panel on an angle to-

ward the inside so that the outside panel can be

lowered and positioned to be installed into the

outside roller track. The inside panel will be po-

sitioned at the showerhead side of the shower

while the outside panel will be positioned op-

posite the showerhead. This is to ensure that no

water escapes through the overlap.

(I)

5) Adjust Rollers. (J) The roller wheels are

mounted to angled slots in the top rail on the

glass. Lowering the roller in the slot raises the

glass. Raising the roller in the slot lowers the

glass. Start out with the rollers mounted in the

middle of the angled slot. If the panel needs to

be adjusted you can remove the panel, adjust

with a screwdriver then, reset the panel. This

might be done one or two times until you

achieve proper alignment. The end result

should be that the vertical edge of the panel is

parallel to your wall jamb to achieve maximum

coverage.

6) Attach the ZV920 Center Guide (#7). Slide

both panels to one end. The front lip of the

guide slips into the slot on the inside of the

J