Installation Guide

until the top rollers can be guided up into the
inside roller track of the header. Lift up panel
then slowly lower the rollers into the inside
rollertrackandletthepanelhanginitsvertical
position.Theoutsidepanelwillbeinstalledthe
sameway.Makesuretherollersarefacingto‐
ward you. A helper would be valuable at this
point to hold the inside panel on an angle to‐
wardtheinsidesothattheoutsidepanelcanbe
loweredandpositionedtobeinstalledintothe
outsiderollertrack.Theinsidepanelwillbepo‐
sitionedat the showerhead side of the shower
while the outside panel will be positioned op‐
positetheshowerhead.Thisistoensurethatno
waterescapesthroughtheoverlap
(I).

5) Adjust Rollers (J). The roller wheels are
mounted to angled slots in the top rail on the
glass. Lowering the roller in the slot raises the
glass.Raisingtherollerintheslotlowersthe
glass.Startoutwiththerollersmountedinthe
middleoftheangledslot.Ifthepanelneedsto
be adjusted you can remove the panel, adjust
with a screwdriver, reset the panel. This might
be done one or two times until you achieve
properalignment.Theendresultshouldbethat
theverticaledgeofthepanelisparalleltoyour
walljambtoachievemaximumcoverage.


6)
AttachtheZV970CenterGuide(#17).
Positiontheguideinthe centeroftheoverlap
oftheglass.Whenthedoorsareinaclosedpo‐
sition the center guide should be centered in
the overlap of the panels. Attach the guide in
place by running a bead of silicone under the
baseoftheZV970CenterGuide.









































