Installation Guide
1)
Findthecenterlineofwheretheunitwillbe
installed. This will usually be the center of the
ledgeofthebathtuborthecurboftheshower
pan.Placeacenterlinemarkateachendofthe
tubledgeorcurbwhereitmeetsthewall.This
mark will also represent the center of the
ZTE2203walljamb(item #9 in exploded view).
Placethewall jamb against the wall, on top of
theledgeorcurb,aligningcenterlinemarks
(A).
If your shower is fiberglass you might have to
filethebacksidecorneroftheZTE2203toara‐
diussothejambsitsasflushaspossibleonthe
ledgeorcurb.Usealeveltopositionthejamb
plumb, then mark the installation holes with a
penorpencil
(B).Repeatthisprocedureforthe
otherjamb.Nowdrill the 6 holes with a 3/16”
masonrybit(9/64”forfiberglass,&withoutan‐
chors).Theninsertthe6)‐ZV935screwanchors
(#10) in the holes. Fasten the ZTE2203 wall
jambs in place using the #8X1‐1/4 Phillips Pan
Headscrewsprovided(#11)
(C).Installthetwo
ZV927bumpers(#12)withthecenterscrewsof
thewalljambs
(D).ImportantNote:TheZV926
BottomBumperneedstobeinstalledwiththe
bottomscrewonthejamb,ontheshowerhead
side of the unit, with the angled side of the
bumpergoingtotheinsideoftheshower.Refer
sideofthebumper
Model FTE & FSE
Install
a
tion Instructions
for
Note:
Theseinstructionswillrefertotheitem#’sintheExplodedViewdrawing.Forexample,#1,#2,#3etc…
Pleasereadthroughalloftheinstructionstogetanover‐viewbeforeyouinstallthedoor.