Installation Guide
totheexplodedviewdrawing.
2)
Measurethedistancebetweentheinsideof
the wall jambs (just above the tub ledge or
curb). Measure tightand deduct 1/16” to 1/8”
togetthecutsizeoftheZTE2222Curb(#8)
(E).
Cut to size. Apply silicone where wall jambs
meet tub or curb
(F). Then run a bead under‐
neath the ZTE2222 Curb
(F2). Slide the curb
down between the wall jambs and onto the
tub/shower. Make sure the curb is solid and
doesn’trockbackandforth
(G).Ifitisnotsolid,
secureitwithtwoofthe#6X3/8”PanHead
Screws (#20) by drilling with a 1/8” drill bit
throughtheoutsidelegofthewalljambatthe
bottom,intothefaceofthecurbandinserting
thescrews
(G2).
3)
Measure the distance from wall to wall
across the top of the jambs. Cut the ZTE6221
Header(#13)tothatdimensionminus‐1/16”.
Slidetheheaderdownoverthetopofthewall
jambs.Theheaderdoesnotneedtobesecured
withscrews
(H).
4)
Install the panels. The inside panel will be
set first. (The inside panel will have the knob).
Thiswillbedoneasyoustandontheoutsideof
theshower.Griponeofthepanelsoneachside
sothattherollersarefacingawayfromyou.Lift
the panel so that the bottom edge clears the
topoftheZTE2222Curbasyouloweritintothe
shower.Continueloweringthepaneldown