Installation Guide

front edge of the ZTE1222 Curb. Position the
guide just to the side of the panels, slip the
front lip in, then snap the guide down over the
inside of the curb. Slide the guide over carefully.
When the doors are in a closed position the
center guide should be centered in the overlap
of the glass
(K). For added security you can at-
tach the guide after it is snapped in place by
drilling with a 1/8” drill bit through the snap in
leg into the curb(from the inside of the shower)
then running a #6X3/8 screw into the hole.
7) Attach the Handle (L) ZTE1207-1.5 (#12) by
placing the Handle Gasket ZV916 (#14) over the
edge of the glass aligning it with the middle wall
jamb bumper (ZV924) on the shower head side
panel. Then place the handle over the gasket
and gently tap onto the glass with a rubber mal-
let.
8) Attach the Towel Bar (M) using the
ZTE1206-1.5 (#9) and the ZTE1206P-1.5 (#10)
Brackets. Follow the same procedure as step 7
aligning the brackets with the middle wall jamb
bumper. The 1206P will be used on the wall
jamb side of the towel bar while the 1206 will
go on the overlap side. After you attach the
brackets slide the Towel Bar ZTE3205 (#11) into
the brackets and secure with 4-#6X3/8 screws.
9) Run a bead of silicone on the gap between
the metal and the shower surface inside and
out. Fill all joints and gaps where metal meets
metal and fill with a fine bead.
(N)