Installation Guide

the ZV924 Bumpers (#4) using the 2-#6/32X1/2
Machine screws (#5) keeping in mind that the
inside panel will be on the showerhead side of
the shower.
2) Measure the distance between the inside of
the wall jambs (just above the tub ledge or
curb). Measure tight and deduct 1/16” to 1/8”
to get the cut size of the ZTE1222 Curb (#6)
(E).
Cut to size. Apply silicone where wall jambs
meet tub or curb. Then run a bead along the
underneath of the ZTE1222 Curb
(F). Slide the
curb down between the wall jambs and onto
the tub/shower. Make sure the curb is solid and
doesn’t rock back and forth. If it is not solid se-
cure it with two of the #6X3/8” Pan Head
Screws (#13) provided by drilling with a 1/8”
drill bit through the outside leg of the wall jamb
at the bottom, into the face of the curb and in-
serting the screws
(G).
3) Measure the distance from wall to wall
across the top of the jambs. Cut the ZTE6201
Header (#8) to that dimension minus -1/16”.
Slide the header down over the top of the wall
jambs. The header does not need to be secured
with screws
(H).
4) Setting of the glass. The inside panel will be
set first. This will be done as you stand on the
outside of the shower. Grip one of the panels
on each side so that the rollers are facing away
from you. Lift the panel so that the bottom
edge of the glass clears the top of the ZTE1222
Curb as you lower it into the shower. Do not set
the glass down on its edge. Be very careful to
not hit the edge on anything. Continue lower-
ing the panel down
until the top rollers can be guided up into the