Arizona Corporate Office 2801 W. Indian School Rd Phoenix, AZ 85017 800-255-1901 PH 602-447-8208 FAX Florida 8100-1 Westside Industrial Dr Jacksonville, FL 32219 855-695-8899 PH 904-786-9025 FAX Illinois 2601 Bond St #1 University Park, IL 60484 800-861-6120 PH 708-235-0729 FAX Oregon 2057 Lars Way Medford.
Installation Instructions for Model MP Door Note: These instructions will refer to the item #’s in the Exploded View drawing. For example, #1, #2, #3 etc… Please read through all of the instructions to get an over-view before you install the shower door. 1) Find the centerline of where the unit will be installed. This will usually be the center of the curb of the shower pan. Place a centerline mark at each end of the curb where it meets the wall.
3) Note: (It will be helpful to have an assistant at this point to adjust and hold the door in place from the outside while you drill and fasten the latch jamb and the hinge jamb from the inside). First you will need to attach the MAG4012 (#4). by placing the ZV 916 for ¼” glass (#23) over the edge of the glass then tapping the MAG4012 over the gasket and on to the glass with a rubber mallet aligning it to the magnet on the latch jamb.(See (F) for help).
) Place a small amount of silicone on the legs of the 2-ZV940 Door Clips (#20) and place down into the top of the 1006’s to cap the opening. You may have to trim them to fit with side cutters (G). 6) Measure in-between the ZD8004 “Magnetic Latch Jamb” and the ZD8004 “Door Hinge Jamb” on top of the curb where the door is going to sit. Cut the ZD2026 to this dimension. Run a bead of silicone underneath the ZD2026 then set in place between the two ZD8004’s. Use tape to hold in place, preferably blue tape (H).