Installation Guide

3) Note
: (It will be helpful to have an assistant
at this point to adjust and hold the door in place
from the outside while you drill and fasten the
latch jamb and the hinge jamb from the inside).
First you will need to attach the MAG4012 (#4).
by placing the ZV 916 for ¼” glass (#23) over the
edge of the glass then tapping the MAG4012
over the gasket and on to the glass with a rub-
ber mallet aligning it to the magnet on the latch
jamb.(See
(F) for help). Square up the door and
align the edge of the door glass parallel with the
latch jamb leaving a 1/16” gap between the
ZD8004 and the MAG4012
(D). Attach the door
by drilling the six holes on the inside of the unit
where the jambs are pre-drilled using an 1/8”
drill bit and secure with the 6-#6X3/8” Pan
Head screws (#8)
(E)
4) Attach the ASD 8X8 Handle (#12). Take the
two stud head mounting screws and sleeve one
clear washer on each screw. Next, insert the
clear grommets into the holes in the door. From
the outside of the door, push the thread of the
screws through the grommets in the holes in
the glass. On the inside of the door, sleeve a
clear washer onto the screws. Take the pull that
has the threaded hole in the end and begin to
thread the top screw into it and then the bot-
tom screw. Tighten the stud head screws down
with a screwdriver (not a drill). This pull will be
on the inside of the door. Place the remaining
pull, with the large holes and set screw, onto
the stud heads of the screws. Tighten the set
screws with Allen wrench provided.
(F).