Arizona Corporate Office 2801 W. Indian School Rd Phoenix, AZ 85017 800-255-1901 PH 602-447-8208 FAX Florida 8100-1 Westside Industrial Dr Jacksonville, FL 32219 855-695-8899 PH 904-786-9025 FAX Illinois 2601 Bond St #1 University Park, IL 60484 800-861-6120 PH 708-235-0729 FAX Oregon 2057 Lars Way Medford.
Installation Instructions for Model R Door Note: These instructions will refer to the item #’s in the Exploded View drawing. For example, #1, #2, #3 etc… Please read through all of the instructions to get an over-view before you install the shower door. 1) Find the centerline of where the unit will be installed. This will usually be the center of the curb of the shower pan. Place a centerline mark at each end of the curb where it meets the wall.
the hinge side wall jamb. Do not fasten the door at this point (D). 3) Note: (It will be helpful to have an assistant at this point to adjust and hold the door in place from the outside while you drill and fasten the latch jamb and the hinge jamb from the inside). Square up the door and align the edge of the door glass parallel with the latch jamb leaving an 1/8” gap between the two (E).
6) Cut the Bottom Poly Rail (ZVP-316WS for 3/16” glass, ZVP-14WS for 1/4” glass) then push over the bottom edge of the glass (I). Run a cap bead of silicone on the inside where the glass and poly meet to prevent water seeping down into the sweep between the glass and poly. 7) Run a bead of silicone on the inside and outside where the wall jamb meets the shower wall. Inspect the install and caulk any gap that might let water through (J).