Installation Guide

1) Find the centerline of where the unit will be
installed. This will usually be the center of the
curb of the shower pan. Place a centerline mark
at each end of the curb where it meets the wall.
This mark will also represent the center of the
ZD1026 Dam Strip (#6) and ZD1006 Wall Jamb
(#1). Measure wall to wall on top of the curb
where the door is going to sit. Cut the ZD1026
to this dimension. Run a bead of silicone under-
neath it then set in place according to the marks
you made. Use tape to hold in place, preferably
blue tape. Place the wall jamb against the wall
and on top of the ZD1026 aligning centerline
marks
(A). Use a level to position the jamb
plumb, then mark the installation holes with a
pen or pencil
(B). Repeat this procedure for the
other jamb. Now drill the 6 holes with a 3/16”
masonry bit (9/64” for fiberglass, & without
anchors). Then insert the 6)-ZV935 screw anc-
hors (#9) in the holes. Fasten the ZD1006 wall
jambs in place using the #8X1-1/4 Phillips Pan
Head screws provided (#10)
(C).
2) Slide the ZD8004 Magnetic Latch Jamb (#2)
over the latch side wall jamb. Install the door by
sliding the ZD2505A Door Hinge Jamb (#3) over
Installation Instructions for
Model R Door
Note:
These instructions will refer to the item #’s in the Exploded View drawing. For example, #1, #2, #3 etc…
Please read through all of the instructions to get an over-view before you install the shower door.