Installation Guide

the hinge side wall jamb. Do not fasten the door
at this point
(D).
3) Note: (It will be helpful to have an assistant
at this point to adjust and hold the door in place
from the outside while you drill and fasten the
latch jamb and the hinge jamb from the inside).
Square up the door and align the edge of the
door glass parallel with the latch jamb leaving
an 1/8” gap between the two
(E). Attach the
door by drilling the six holes on the inside of the
unit where the jambs are pre-drilled using an
1/8” drill bit and secure with the 6-#6X3/8” Pan
Head screws (#8)
(F)
4) Attach the ZD4011A Mag Handle (#7) to the
door glass by placing the Handle Gasket (ZV 916
for ¼” glass or ZV917 for 3/16” glass) (#23) over
the edge of the glass then tapping the handle
over the gasket and on to the glass with a rub-
ber mallet aligning it to the magnet on the latch
jamb
(G).
5) Place a small amount silicone on the legs of
the 2-ZV940 Door Clips (#20) and place down
into the top of the 1006’s to cap the opening.
You may have to trim them to fit with side cut-
ters
(H).